Skip to main content

Enable reading and writing data across shards in Aiven for ClickHouse®

If your Aiven for ClickHouse® service uses multiple shards, the data is replicated only between nodes of the same shard.

When you read from one node, you see the data from the shard of this node. Creating a distributed table on top of your replicated table, while the distributed table itself doesn't store data allows you to see data from all the shards but also help spread the data evenly across all the cluster nodes.

Set up a sharded service with a database​

  1. Create an Aiven for ClickHouse® service with multiple shards.

    note

    Shards are created automatically when you create an Aiven for ClickHouse services. The number of shards that your service gets depends on the plan you select for your service. You can calculate the shards number as follows: number of shards = number of nodes / 3.

  2. Create database test_db in your new service.

Create a distributed table​

  1. Connect to your database.

  2. Create a table with the MergeTree engine as shown for the cash_flows table in the following example:

    CREATE TABLE test_db.cash_flows
    (
        EventDate DateTime,
        SourceAccount UInt64,
        TargetAccount UInt64,
        Amount Float64
    )
    ENGINE = MergeTree()
    PARTITION BY toYYYYMM(EventDate)
    ORDER BY (EventDate, SourceAccount)
    note

    With Aiven for ClickHouse, you can specify ENGINE either as MergeTree or as ReplicationMergeTree. Both of them create a ReplicationMergeTree table.

  3. Create distributed table cash_flows_distributed with the distributed engine:

    CREATE TABLE test_db.cash_flows_distributed AS test_db.cash_flows
    ENGINE = Distributed(test_db, test_db, cash_flows, SourceAccount)

Verify your distributed table​

Check if the distributed table you created is available and if you can use it to access your data from all the shards.

  1. Run a read query for the number of table rows:

    SELECT count() FROM test_db.cash_flows_distributed

    As a response to this query, you can expect to receive a number of rows from all the shards. This is because when you connect on one node and read from the distributed table, ClickHouse® aggregates the data from all the shards and returns all of it.

  2. Run a write query to insert new data into the distributed table:

    INSERT INTO test_db.cash_flows_distributed (
      EventDate, SourceAccount, TargetAccount, Amount
    )
    VALUES (
      '2022-01-02 03:04:05', 123, 456, 100.0
    )

When you insert data into the distributed table, ClickHouse® decides on which node the data should be stored and write it to the correct node making sure that a similar volume of data is written on all the nodes.